Hallo zusammen!

ich habe folgendes Problem:
ich verwendet Miktex und TeXnicCenter..
Da ich im Anhang sehr viele Postscripts (*.ps) einfügen will, stelle ich auch das Ausgabeprofil auf Latex-->PS.

so nun läuft alles Durch: 0, Fehler, 5 Warnungen, 0 zu volle/leere Boxen, 16 Seiten

Wenn dies nun im GSView geöffnet wird kommen folgende Meldungen:
_____________________________
DSC Warning at line 6051
%%trailer
The trailer is normally at the end of a document.
This line was found more than 32k bytes from the end of the file. Trailers are nur usually this long.It is more llikely that another PostScript file has been included, without enclousing it in %%BeginDocument/%%EndDocument.

"Ok" will assume this part od an included file.
"Cancel" will assume this in the trailer
______________________________
die kommt dann noch ein paar mal...mit verschiedenen Zeilen und dann kann ich mir die Seiten bis zu den eingefügten *.PS ansehen, das erste *.PS sehe ich auch noch, wenn ich dann weiterblättere kommt ne Fehlermeldung und dann geht im GSView nix mehr..:

%%EndDocument
@endspecial 4876 77 a
currentpoint grestore moveto
4876 77 a 293 77 a
currentpoint currentpoint translate 1 0.52153 div 1 0.52153 div scale
neg exch neg exch translate
293 77 a Black
1430 2632 a Fl(Abbildung)
--- End offending input ---
file offset = 356150
gsapi_run_string_continue returns -101


Was kann ich da tun????

danke für eure Hilfe!