stax
02-05-2006, 16:14
Also, mein Problem ist folgendes: Wenn ich meine Quelldatei mit latex ohne jegliche Optionen kompiliere, dann werden die Bilder falsch nummeriert. D.h. in der Bildunterschrift steht die richtige Nummer (im Beispiel 1) im Text steht dann allerdings wenn ich das label mit \ref aufrufe eine um 1 höhere Nummer (im Beispiel 2).
Hier einfach mal der Quelltext
\documentclass{article}
\usepackage{graphicx}
\begin{document}
\title{Dualism in QM}
\author{US}
\date{\today}
\maketitle
\section{Introduction}
\section{Duality according to Englert}
\begin{figure}
\begin{center}
\includegraphics[scale=0.3]{../Bilder/interferometer.eps}
\label{interferometer}
\caption{the setup}
\end{center}
\end{figure}
Englert uses a very basic two way interferometer to treat duality theoretically. A beam of quantons is split by a beam splitter into two. Its two possible ways are labeled +1 and -1. Along these paths, one puts a phase shifter two measure change the relative phase of the two beams. After that, a beam merger leads the two paths back together. This setup is analysed. Afterwards, a which way detector is inserted into each of the beams, which just changes its state if the particle passes, without affecting the particle. The whole setup is shown in Fig.~\ref{interferometer}.
\end{document}
Würde mich über Vorschläge freuen, denn ich bin absolut am Ende mit meiner Weisheit.
Hier einfach mal der Quelltext
\documentclass{article}
\usepackage{graphicx}
\begin{document}
\title{Dualism in QM}
\author{US}
\date{\today}
\maketitle
\section{Introduction}
\section{Duality according to Englert}
\begin{figure}
\begin{center}
\includegraphics[scale=0.3]{../Bilder/interferometer.eps}
\label{interferometer}
\caption{the setup}
\end{center}
\end{figure}
Englert uses a very basic two way interferometer to treat duality theoretically. A beam of quantons is split by a beam splitter into two. Its two possible ways are labeled +1 and -1. Along these paths, one puts a phase shifter two measure change the relative phase of the two beams. After that, a beam merger leads the two paths back together. This setup is analysed. Afterwards, a which way detector is inserted into each of the beams, which just changes its state if the particle passes, without affecting the particle. The whole setup is shown in Fig.~\ref{interferometer}.
\end{document}
Würde mich über Vorschläge freuen, denn ich bin absolut am Ende mit meiner Weisheit.